How to Back-Paint on Glass and Remove Common Glass Paint Mistakes – Steps
Many
times you are not satisfied with the output when you are painting on glasses. Many
a time you are unaware about how to paint on glass. Also, you will want to
correct the mistakes. There are certain ways to avoid certain mistakes while
painting on glass. Further if you need to remove the glass paint, the steps are
below.
How to Back Paint On Glass?
These
easy steps will ensure a perfect output.
Stage 1 – Setting Up
·
Start with mixing the paint and the catalyst.
·
Clean the glass. Use paper towel soaked in
alcohol and run it over the glass.
·
Pour the paint mixture into the hand spray
gun.
Tip:
While pouring the paint, run it through a strainer. It will help you remove
foreign particles if any.
Stage 2 – Painting
·
Start applying the first coat using the painting
gun. Paint it in UP and DOWN motion.
·
Wait for 5 minutes before applying another
layer.
·
Repeat the above two steps until you’ve
applied at least 4 layers
·
Leave the paint to bond for 48 hours.
How to correct mistakes while painting
on glass?
The instructions
here will solve your problems no matter the type of paint you are using. (Water
Based, non-water based, Markers or GlassPrimerTM)
Some Common Glass Paint Mistakes
Considering
the type of project you are into, mistakes vary.
·
For back-painting it will be overspray or
spillage.
·
For markers or acrylic pastes it can be
scribbles and what not!
Thus,
the instruction below will be helpful.
Steps to Solve Mistakes on Back-Painted
Glass
·
If there is some spillage on the frontal part
of the glass, use a lacquer thinner for cleaning.
·
Use a light steel wool for removing overspray
at the edges. Use a single edge razor if the overspray is too thick.
·
Repeat the above steps of stage two on the
dedicated spaces and give your painting a finishing touch.
Tip:
Clean paint from the gun using lacquer thinner. For the best results spray the
thinner for a minimum of 30 seconds. This will give the equipment a longer
life.
Steps to Solve Marker or Acrylic Paste
Mistakes Completely
Since, glass paint
products are product are methylated spirits, the process will be the same. These paints can be removed with clean meths.
Getting Started –
Mise-en-Place
·
Take some
methylated spirit in a container. Cover it with a lid.
·
Spread a paper on the table and place the
glass on top of it.
·
Gather some cotton buds.
The Process of
Cleaning
·
Dip one end of the cotton bud into the
methylated spirit.
·
Hold one end on top the mistake and roll it
with gentle hands. Keep the motion away from you.
·
Notice that the methylated spirit soaked cotton
buds with absorb the paint.
·
Repeat the steps a few times and remove all
mistakes.
Start Over
If you are cleaning it whole, then you will need to start
over again. But if you are satisfied with removing the mistakes, make sure to
paint them back.
Don’t
forget to share this post if it aided some help to you. Keep practicing and
play around with glass paint. Feel free to make mistakes. It will help you get
more command on your skills. Be confident and prepare the best artworks you
can.
Good
Luck
Comments
Post a Comment